Estate Swing Bedienerhandbuch PDF herunterladen (Seite 30)

E-S 1000D Series Instruction Manual

Easy Wiring Under Driveway

3.4

This portion of the manual will explain how to

create an easy conduit for the wires for dual

gates.

This is what you would need to get started:

- Narrow shovel.

- ¾’ water pipe no more that 5’ in length (you

would need a total number of pipes that would

equal your driveway width plus 1’).

- ¾’ electric rigid pipe couplings (one for each

joint in the water pipe).

- 1 ¾’ “Tee”

- 1 ¾’ Plug.

- 1 ¾’ male galvanized pipe X female hose fit-

ting (usually in Brass).

- Large hammer.

All the above items could be found in a local

home supply store.

Dig a trench perpendicular to the driveway

approximately 6 to 8 inches deep and 6’ long

Hook up a typical garden hose assembled

to the first length of pipe as shown

Turn on water and push the pipe under the

driveway, matching the pitch of the driveway.

If you hit a rock use the hammer to force the

pipe past the rock.

Attach additional pieces of pipe to the initial

length by removing the tee and using the cou-

pling to add the additional length of pipe, reas-

semble the tee and repeat the above steps until

only 6 inches of pipe is sticking out from under

the driveway. On the opposite side of the drive-

way look for a wet spot or water bubbling up,

dig to find the end of the pipe.

This process is good for driveways up

to 24’ in width.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 56 57

Kommentare zu diesen Handbüchern

Keine Kommentare