Estate Swing Bedienerhandbuch PDF herunterladen (Seite 21)

5. Temporarily position the gate side

mounting bracket. (horizontal position

does not matter, vertical position on the

gate is the position you are matching to

the post bracket.) Position your assem-

bled gate mounting along the previously

drawn vertical line and level the angled

piece with the horizontal piece of the gate

mounting bracket using a level. Mark

your holes, drill and attach the brackets

using 4) 3/8” carriage bolts.

6. Assemble the rear fitting to the operator as shown below.

7. Run the 5 wires from the arm(s) to the control board as seen in section 3.

8. Set the operator for manual operation. And extend the operator arm slightly past the full

retracted position..

2.12

Gate Side Bracket

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Keine Kommentare

Estate Swing Bedienerhandbuch Seite 21