Estate Swing Bedienerhandbuch PDF herunterladen (Seite 13)

Installation of Operator—Pull-to-Open

1. Find the proper set back for your operator (from

previous page). Do this by holding the bottom “L”

shaped bracket against the post. Marking its horizon-

tal positioning on the post using a vertical line up

from the middle of the bracket. Also mark your an-

gled bracket for positioning on the “L” shaped

bracket. The hole on the end of the angled bracket

should be in the setback position.

HINT: Trace the bracket on cardboard and use

the cardboard to make a template.

2.4

2. Cut off the excess length

(if any) of the angled

bracket using a hacksaw.

3. Position the angled

bracket between the two “L”

shaped brackets in the same

position as when the setback

was found. Clamp the 3

brackets together. Drill

through the angled bracket

using the pre-drilled holes in

the “L” shaped brackets us-

ing a 3/8” drill bit. Drill

through all three brackets

using a 5/16” drill bit in a

position behind the first

hole.

4. Insert a 3/8” x 1” bolt in

the center hole and a 5/16”

bolt in the rear hole. Secure

them using the provided

nuts and lock washers.

Before permanently attaching any brackets, be sure to test

arm motion and clearance.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Keine Kommentare

Estate Swing Bedienerhandbuch Seite 13